Author Topic: DHCP scope  (Read 723 times)

geethu

  • Green Belt
  • *****
  • Posts: 475
  • Karma: +0/-0
DHCP scope
« on: February 10, 2016, 06:47:00 PM »
What is DHCP scope?

A scope is a range, or pool, of IP addresses that can be leased to DHCP clients on a given subnet.

radhika

  • Brown belt
  • ******
  • Posts: 596
  • Karma: +0/-0
Re: DHCP scope
« Reply #1 on: February 15, 2016, 02:10:10 AM »
A Dynamic Host Configuration Protocol (DHCP) scope is the consecutive range of possible IP addresses that the DHCP server can lease to clients on a subnet. Scopes typically define a single physical subnet on your network to which DHCP services are offered.

siljy.datasoft

  • Green Belt
  • *****
  • Posts: 453
  • Karma: +0/-0
Re: DHCP scope
« Reply #2 on: July 05, 2016, 02:00:34 AM »
hi

Configuring a DHCP Scope

Applies To: Windows Server 2008 R2
A scope is an administrative grouping of IP addresses for computers on a subnet that use the Dynamic Host Configuration Protocol (DHCP) service. The administrator first creates a scope for each physical subnet and then uses the scope to define the parameters used by clients. A scope has the following properties:
A range of IP addresses from which to include or exclude addresses used for DHCP service lease offerings.

A subnet mask, which determines the subnet for a specific IP address.

A scope name.

Lease duration values, which are assigned to DHCP clients that receive dynamically allocated IP addresses.

Any DHCP scope options configured for assignment to DHCP clients, such as Domain Name System (DNS) server, router IP address, and Windows Internet Name Service (WINS) server address.

Reservations, optionally used to ensure that a DHCP client always receives the same IP address.

Thankz

hruthika

  • Brown belt
  • ******
  • Posts: 872
  • Karma: +0/-0
Re: DHCP scope
« Reply #3 on: October 13, 2016, 03:58:14 AM »
A scope is an administrative grouping of IP addresses for computers on a subnet that use the Dynamic Host Configuration Protocol (DHCP) service. The administrator first creates a scope for each physical subnet and then uses the scope to define the parameters used by clients.